Product search:

Service Wrench for Impact Tip Replacement

Home
Product
Service
Distributor
About Us
Contact

Welcome to
Digiwork
Get better
Instruments

Thickness TestersThickness PartsHardness TestersHardness PartsFlaw DetectorsRoughness TestersRoughness PartsDigital Multimeters

Call 905-669-1663

 

Home > Products > Hardness Parts >

A Pair of Service Wrench for Impact Tip Replacement

Price: US $69.00

The ball needs to be replaced if it has been worn off. Replace the ball in the following steps as shown in the pictures:

  1. Mark a line with pencil on nut and body indicating the position of nut.

  2. Unscrew the nut with the special wrench provided. The large end of wrench is for G impact device and the small end is for D, DC, D+15 and C. Remove the worn ball.

  3. Hold the body upright. Put the new ball on the platform of body. The ball has a small flat surface and this surface should be in full contact with the platform of body.

  4. Screw the nut back to the body tightly by hand.

  5. Tighten the nut with the special wrench until the nut comes back to the marked position or passes over the marked position slightly.

IMPORTANT: the flat surface of ball must be kept in full contact with the platform of body in step 4 and 5.

Picture

 

© 2016 Digiwork Instruments, All Rights Reserved.